Deansteel standard door frames use the time-tested method of die cut mitered corners with integral tabs for its corner assembly. This assures secure locking of jambs to head with a minimum of time and effort.

D Series Specifications
Standard Frames are manufactured from 16 Ga. [1.3mm] cold-rolled steel. Frames are thoroughly cleaned and phosphatized to resist corrosion before receiving one coat of gray rust inhibiting primer.

Standard frames come in these jamb depths:

4-3/4" [121mm] 5-3/4" [146mm] 6-1/4" [169mm] 6-3/4" [171mm]

7-1/8" [181mm] 7-3/4" [197mm] 8-1/4" [210mm] 8-3/4" [222mm]

They are pre-punched for silencers, furnished with welded in plaster guards, 7 Ga. [4.3mm] hinge reinforcements and 16 Ga. [1.3mm] combination strike reinforcements and mortar guards.

• All 1-3/4" [45mm] door frames are prepared for ANSI-A115.1 and ANSI-A115.2, 4-7/8" [124mm] strikes.
• All 1-3/8" [35mm] door frames are prepared for ANSI-A115.2, 2-3/4" [70mm] strikes.
• Hinge preparations for 1-3/4" [45mm] door frames are 4-1/2" [113mm] template type and 3-1/2" [89mm] for the 1-3/8" [35mm] doors.

Masonry/ Drywall Frames (D Series)

Knock Down Corner Detail	Snap-In Wall Anchors
Strike Reinforcement	Masonry Wall Anchors
Floor Anchors